This is how I make a new oil pressure line for the 1944 2N

Little update on the 2n ford fuel tank

We need to do a lot of cleaning and make a new steering housing gasket 1944 Ford 2n

1944 2N...Let's connect the back and the front sections then remove the steering/shifter top

1944 Ford 2N flywheel installation and clutch replace

Let's burn the new table down heating this flywheel to remove the ring gear 1944 2N Installation

Let's install the input shaft in the 1944 2N...also some brazing to repair a clutch rod "pin" hole

Let's start the re-assembly of the Ford 2N input shaft.. New seal installation

Let's do some more work on the 1944 2N...Big SNAG today though

1944 29N lets get the flywheel off and service it and remove the sherman trans

Today is the BIG day...Let's Split the 1944 2N and see whats going on inside

1944 Ford 2N...Let's Rebuild the Axle front end pivot and check for any play

1944 Ford 2N...Let's drain the coolant and remove the old rad Venture into the axle pin replacement

Wholly Cow that part sure showed up wicked quick...Go Amazon...1944 Ford 2N

Starting the stripping

Let's install the new front tires and tubes..1944 Ford 2N 4.00X19

2n parts haven't arrived but lets try to get her going again for plow day. Also front tire removal's

Let's inspect the Ford 2n front bearings and axles...Also a mega issue with the 0 turn Mower

1944 Ford 2N...Let's change the wore out tie rods

1944 Ford 2n Governor oil line bypass (from filter) build and installation and how a governor works

1944 Ford 2N governor Change and examine the old one

Let's reassemble the '44 2n rear axle and brake assembly also the tire and rim

Brake parts are in for the '44 Ford 2n lets install them and a new seal

Quick parts update for the '44 Ford 2N

BIG CAN OF WORMS OPENED UP....1944 2N right side brakes

Let's get one new rubber installed and beat apart the hub for a brake inspection.

Part 2..1944 2N oil change finish up...You'll never believe what I found wrong

Oil change series....Next up..1944 Ford 2N its been a long time for this one you'll see! OMG!

Plow Day with Bill and the 2n Ford Will she still pull??...Let's See

Will she start the second day. Check out my new Instagram at billstmaxx29

The Conclusion....Will it run?? Let's see

Let's get the rest of the wiring finished up on the Ford 2N

1944 Ford 2N..Pulling new spark plug wires and new ammeter install

1944 Ford 2N front mount distributor rebuild

Well...The 2N did run good...Something went wrong...Let's check the distributor out

Well Let's see if we can get this 2N to run...Cross fingers!

Lets do some electrical work on the 2n and see if she will start up (Special Guest today)

Let's do some work on the 1944 2N...New crank handle and air and fuel system refurbish

Little Clarification on the 1944 Ford 2N starter video from recent (Fan spinning the wrong way)

Let's do some work on the 1944 2N.....Test the old starter

This 2N Fuel tank...Let's clean it up do some Brazing and pressure test it

Ford 2N...Let's fire it up...Somethings wrong though ?

1944 2N New radiator install and fill up

Let’s try a cold start on the Ford 800 tractor... -6c or 21f

1944 2N clutch rod look at and a cheat for sloppy radius rods..Installation

Let's build a new clutch actuator rod for the Ford 2n (the proper straight one)